“Let’s deal with problems well water system owners face and how to solve them.”
Whether you just got a new home with a well water system or you installed a new one, you must have faced problems with the water pressure already. Its mostly at the lower end. If you haven’t faced any trouble yet I would suggest buying lottery tickets before you luck runs out. Well I had a major issue with my system and called over a local plumbing and gas service provider to address the issue.
Here’s what I learnt:
-
Identification of the issue: Goes without saying, one needs to identify a problem before attempting to fix it. Instant gas hot water in Perth is something that also faces low water pressure issues. Whenever you face low pressure through faucets or shower heads, it denotes a recurring problem with the water supply unit. You may be tempted initially to call in an emergency plumber in Perth to change the faucet but even he will tell you that there’s a major dip in water pressure and it is related to the well water system and not the faucet. The three most common issues noticed with this are: over consumption of water, consumption of water over long time periods and the occasional drought.
-
Taking a look at your pressure tank: Well its quite obvious that pressure tank is the first place to inspect when dealing with pressure issues. Even a blocked drains Perth or shower installation Perth official will tell you that the ideal measurement on the pressure gauge should be between 40 and 60 Psi. There is a proper and professional way to do this, so pay attention.
-
Cut of the power supply to the well water system.
-
Put an air pressure measuring gauge into a valve and wait for the level to stabilize.
-
If the pressure rating falls below 40 Psi even shower installation Perth experts are quick to adjust the knob to increase the pressure. Sometimes it’s the switch that is faulty. They are changed as well.
-
The next step is to turn the power back on and notice the changes.
-
The above steps are repeated as necessary until ideal water pressure is achieved.
-
Monitoring the connections:It is also important to check the connections. A clogged waterline can be the underlying reason to the low water pressure and a local plumbing and gas official will be the first to tell you that. Last time I called an instant gas hot water Perth expert he my mentioned problems with water pressure might be due debris clogged in the pipe. It is often rust, minerals and metal debris that causes clogging. It happens overtime and to everyone.
-
Pressure Regulator: A supply line pressure regulator is not something every home owner has access to. This luxury presents itself to homes with a direct connection to the water tank owned by the municipal corporation. There are regulatory valves present at connection bridges for home owners to alter the water pressure as desired. My 24-hour plumber in Perth taught me this handy trick when he was dealing with my water pressure problems. The valve is almost always located behind the main water meter. You could locate and regulate water pressure on your own but I advise calling in an emergency plumber in Perth to show you if it’s the first time.
-
Installing a new pressure system: It applies to a well water system as well. There are some issues which call for total replacements as repairs are some times not possible. To get a new constant pressure system installed you might need to call in 24-hour plumber in Perth. Well water systems do give out on pressure eventually and you will need to install one of these soon if you haven’t already. The pressure dip happens generally when there are multiple fittings, but this handy dandy fixture should handle all of them like a charm.
Water pressure problems are not hard to spot and should be addressed with immediate effect as they may lead to severe issues with the main water line. Call a local plumbing and gas service provider to get yours checked.
